Note the pattern number on the bottom right-hand corner of the cover page. The first number refers to the pattern and the number after the decimal is the numbered revision (e.g. #2.2 is Chloë, revision number 2). Corrections are listed by most recent revision number. Text in red is the corrected wording.
Row 1 (RS) : …
Row 2 (WS) : …
Reworked the sleeve for a slightly larger sleeve cap. This affected all the increases and final stitch counts.
Change to larger needles and working in patt, inc 1 st at each edge of next row, then every foll 4th row 10 (13, 19, 9) times, (64 (76, 88, 74) sts), then every foll 6th row 4 (4, 2, 13) times. 72 (84, 92, 100) sts.
Final st count after decreasing for the sleeve cap.
60 (66, 74, 82) sts.
Final sleeve measurements as indicated on final page of pattern.
|9 ½ (11 ¼, 12 ¼, 13 ¼) in
24.5 (28.5, 31, 34) cm
Pattern innovation providing instructions for premeasured lengths for working the intarsia section on the back of the sweater.
Before you start knitting, wind off a 165 (185, 210, 245)” [4.2 (4.7, 5.4, 6.3) m] long length of CC to be used when working the rectangular patch detail on the upper back.
Rectangular patch detail: The rectangular patch detail is worked in intarsia. You will need to cut short lengths of yarn from the jacquard and solid sections of a ball of MC. To minimize the number of ends to sew in, the jacquard sections should be worked with one 66″ (168 cm) long length of yarn which is carried at the back of the work to each of the knitted jacquard sections of the detail. In addition, select two different colours from the solid sections of MC and cut each 40″ (102 cm) long.